BRI Channels on ARN

[mbhandari]

Hi Guys,
How can you access individual channel on BRI port on ARN as in Cisco you can specify bri1/1:0 or bri1/1:1
I have checked BCC also but of no use.
When you specify Demand circuit it shows only Channel count 2
-Mohi

 

[swasti]

you can configure Channel count in 1B+D option while specifying the number of channels you want to use. This will make your router to use only single channel instead of 2.

 

[mbhandari]

Thats correct, but it will give u only one channel. If tommorow u need to access the second channel then u have to delete the all dial and port config.
As I have gone throug Nortel Doc- nowhere it metion about the channel.
You can on Dial-demand/Backup-demand specify channel-count 1, so it will take only one channel on FIFO bases.