Brain Fart on my part

[WOTRS]

I have a customer that has three BCM 400 systems running 3.7.
Site - A has two PRI's. The customer wants Site - B and Site - C to make outgoing calls on the Site - A PRI's. The three systems are connected with MPLS and can call between each other now. For the life of me I can't remember how to make this work! HELP?

 

[SupportDude]

You need to configure Des Codes and Routes at site B & C that point to site A.
Send along the "9", or whatever you are using to route calls to PSTN at site A, when you send the call from B or C.

-SD-

http://www.mysupportguy.net

 

[WOTRS]

I built routes at Site-B and Site-C that point to the VoIP trunks that connect the three system. They are set as National and delete 0 digits. The Des code is 9A. At Site-A Des code 9A points to the PRI.

 

[madwok]

You also need to allow the VOIP trunk remote access to the PRI on site A.

 

[WOTRS]

That's where the brain fart come in. I can't remember.

 

[SupportDude]

Yep ...
Sorry about that!
Had a small one myself.

-SD-

http://www.mysupportguy.net

 

[gecko202002]

Setup remote access packages - in the package allow pool access for VOIP trunks and PRI trunks. Apply this package to the actual trunks. Remote packages are found under Services > Telephony Services > General > Remote Access Packages. Then apply the package to the Lines on the General tab.