BP250 H323 TRUNK

[miranpiscanc1]

Hello everyone. Those who have already had occasion to set up a BP250 to be connected via H323 with another telephone exchange. To clarify, I need to connect a BP250 that has on board the IPU with UCP100 Ericsson / LG.
Thank you all.

Miran Piscanc

http://www.mpcommunications.it

 

[xs650]

I have once connected a MFIM50B to a BP250 via H323 trunk,
so what excatly is your question?

 

[miranpiscanc1]

Perfect, the UCP100 is the evolution of MFIM50B. Just that I was looking for. How do I program the BP250 to connected via trunk h323 with MFIM50B? What settings have to follow?
Thanks


Miran Piscanc

http://www.mpcommunications.it

 

[xs650]

-create a route with IPU channels
-in the menu Network Ip address set:
Node Ref: 1
Signalling Protocol:102
Network Ip address: Ip of the UCP
Port number: 1720

-set 2194 to 1720 and 2185 to 17200
-create a PNR which routes the wanted numbers to node ref 1(9117)
Destination PBX must be "Other vendor PBX"

 

[miranpiscanc1]

Thank you,
on BP I made these settings, but do not know how to set the MFIM50?

Miran Piscanc

http://www.mpcommunications.it

 

[miranpiscanc1]

I add an indication: the BP makes the call as seen by the firewall, but the MFIM log does not know what to do, so it does not sound anything

for privacy I masked some figures of public IP

Miran Piscanc

http://www.mpcommunications.it

 

[xs650]

In UCP put some CO lines in an own CO group.
Type should be common or H323.

The other programming for incoming calls depends what you send with BP.
When you just send the station number you can use "use as is"
and the station should ring.

For calls from UCP to BP you can program networking or LCR.
When you use networking feature you need a networking license in UCP.

 

[miranpiscanc1]

Thank you.
I attach a few screenshots to show the programming of UCP, because I still can not run.
BP sent directly from the extension number.

.

Miran Piscanc

http://www.mpcommunications.it

 

[xs650]

I have just made a quick test with an eMG80 and a BP250 and it is still not working here.
There seems to be some changes in the H323 networking compared with a MFIM.

As we don´t sell ELG any longer I have no idea how it is working with this unified software
that UCP, eMG80 and eMG800 uses...

 

[miranpiscanc1]

Thanks.

I await possible verification.

Miran Piscanc

http://www.mpcommunications.it