Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BP 250 BTU-D ISNN PRI

Status
Not open for further replies.

teenu3

Technical User
Jul 20, 2012
98
IN
Hi All,

i have a isdn pri DID range from 100 to 199. in comming call is okey like xxxx102 it ring in ext 102, when I dial to my cell phone from ext 102 my cell phone shows only the pilot number which is not a DID NUMBER. How can i get number xxxx102 in my cell.

Thanks in advance.

regards
 
How to send the number is very country dependent, so it is hard to give a tip.
We send local area code and subscriber number from cmd 2220 as typ national plus
the DID from the extension.
If we send a wrong number the provider still send the pilot number to the other side.
regards
XS
 
Thanks Xs 650,

Why am asking is the very next building same providers isdn pri with cisco call manager the other party can see the number when they receve a call from cisco system. the provider told me both the line are same. that is why.

Regards
 
teenu3,

hope this helps if you haven't resolved it yet:

cmd 1023 set to 67
cmd 1804 set to 1

in cmd 2220 enter the the full telephone number that is a prefix of the ddi
cmd 2224 set to unknown or national
cmd 2260 is the ddi table that needs to be populated for all of above to work..

so eg if your DDI number was 01234 882256 and your extn is 256 and you revice 4 digit DDI from network
the following must be relevant

cmd 2220 0123488
cmd 2224 national or unknown
cmd 2260 internal dir = 256 ddi #1 = 2256

if you set to above whenever you call out from 256 the full ddi will be sent to other party.

aastratech !
 
Thanks aastratech,

for the tips and solved the problem.

thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top