Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Boson Netsim-Can't bring up serial interface

Status
Not open for further replies.

MJ6

IS-IT--Management
Nov 19, 2002
54
GB
Been trying to use Boson netsim and can't even bring up a serial interface between two routers! Also,it wont let me input the clock rate ("Ambigious command"). I've nearly finished my CCNA so I know its not me. Anyone any tips on any known bugs or fixes on Boson v.6?

I wanna revise for final exam but cant. HELP!
 
I've nearly finished my CCNA so I know its not me"

Just becuase you have done that it doesnt make you always correct.

I checked on my Version 6 and had no problems, did you set the clock rate on the DCE? and did you use a correct value ie clock rate 64000 ?? I used boson through the 6.0 beta and final beta without any problems.
 
Turns out I was correct. Stupid Boson needed clock rate setting as 56k not 56000!
 
I had a network built on Boson Beta v6, and R1, R2 and R3 all connected to eachother (no redundancy). R1 could ping R2 and R3, R2 could ping R1, but NOT R3, and R3 could ping R2, NOT R1. This I believe is a definite bug. Also, I am able to use 56000, 64000 and 125000.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top