Greetings to all, I'm about to replace an old Clarity paging system with a Bogen UTI1 that will be connected to a G430 which is also new. I've connected the paging system to analog ports on both an MM711 & MM716, without any success, and I'm wondering which is the best to use, or do I need a "middle man", some other type of interface between the G430 and the UTI1? If anyone has a successful config, and assistance would be greatly appreciated. Thanks In Advance.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Bogen UTI1 & analog port
- Thread starter tone70
- Start date
dialtonebone
Technical User
<<This will tell you everything. My preference? go to Page 9, configure for loop start station/analog station. Plug into an analog part, create a station. Now you should be able to call the station to access the UT1.
The UT1 needs to be connected to the paging system, it doesn't really replace the paging system.
The UT1 needs to be connected to the paging system, it doesn't really replace the paging system.
- Status
Similar threads
- Locked
- Question