Blue screen in windowsXPpro

[Guest_imported]

What could be causing these blue screens to happen, this is the error report I am getting after I have rebooted...

BCCode : 76 BCP1 : 00000000 BCP2 : 822FF020
BCP3 : 00000002 BCP4 : 00000000 OSVer : 5_1_2600
SP : 0_0 Product : 256_1

also, the blue screen says..." LOCKED_PAGES " PREFORMING MINIDUMP.

any help would be greatly appreciated.

 

[Guest_imported]

Here are the codes I get on the blue screen

*** stop : 0x00000076
(0x00000000,0x81c6b200,0x00000002,0x00000000)

 

[Guest_imported]

Here are the codes I get on the blue screen

*** stop : 0x00000076
(0x00000000,0x81c6b200,0x00000002,0x00000000)

 

[jazzgirl]

You can start by searching here

http://support.microsoft.com/default.aspx?scid=fh;rid;kbinfo.

Put the error number in and hit search.

HTH

jazzgirl

 

[Guest_imported]

Thanks...but I've tried that already, with no results.

 

[Dynamo99]

Dunno if this will help, but you may want to remove the cards from the system so that it boots with only the video.. then add 1 card at a time until the error shows up.. You may then be able to determine what is causing the problem. Sounds like it's loading a driver that it don't like...
Jim

 

[oroboros]

I have this same error message. Has anyone figured this out yet?

 

[linney]

http://msdn.microsoft.com/library/default.asp?url=/library/en-us/w2kmsgs/6077.asp

Error Message:
STOP: 0x00000076 (parameter, parameter, parameter, parameter) PROCESS_HAS_LOCKED_PAGES

Explanation:
This is a Windows 2000 Executive character-mode STOP message. It indicates that a process terminated with pages locked for I/O.

User Action:
If this is the first time you have booted after installing new hardware, remove the hardware and boot again. Check the Microsoft Hardware Compatibility List to verify that the hardware and its drivers are compatible with Windows 2000. For information about the hardware, contact the supplier. If you are installing Windows 2000 for the first time, check the Windows 2000 system requirements, including the amount of RAM and disk space required to load the operating system. Also, check the Hardware Compatibility List to verify that the system can run Windows 2000. If Windows 2000 is loaded and no new hardware has been installed, reboot with recovery options set to create a dump file. If the message continues to appear, select the Last Known Good option when you reboot. If there is no Last Known Good configuration, try using the Emergency Repair Disk. If you do not have an Emergency Repair Disk, contact your technical support group.




A General way to troubleshoot Stop Errors.......




If you’ve recently added new hardware, remove it and retest.
Run hardware diagnostics supplied by the manufacturer.
Make sure device drivers and system BIOS are up-to-date.
However, if you’ve installed new drivers just before the problem appeared, try rolling them back to the older ones.
Open the box and make sure all hardware is correctly installed, well seated, and solidly connected.
Confirm that all of your hardware is on the Hardware Compatibility List. If some of it isn’t, then pay particular attention to the non-HCL hardware in your troubleshooting.
Check for viruses.
Examine the System Log and Application Log in Event Viewer for other recent errors that might give further clues.
Investigate recently added software.
Examine (and try disabling) BIOS memory options such as caching or shadowing.