Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

blocking a call using CLID

Status
Not open for further replies.

bullitrider

Technical User
Nov 8, 2005
10
CA
Hi, i got a CCM3.3 with PRIs on a 3725gw and i want to block a certain phone number from entering the CCM. MGCP is enable and i'm wondering if i were to use dial-peer commands below, will it work? I'm thinking not, because of MGCP is taking over the PRI

voice translation-rule 1
rule 1 reject /6045551212/ <<<<-------- filter out calls
voice translation-profile reject_ANI
translate calling 1
dial-peer voice 4 pots (make it the same as my current)
destination-pattern 9T
direct-inward-dial
port 1/0:23
call-block translation-profile incoming reject_ANI
call-block disconnect-cause incoming user-busy
________________

what's config on the GW
ccm-manager mgcp
ccm-manager config server x.x.x.x
!
voice-port 1/0:23
!
Controller t1 1/0
framing esf
linecode b8zs
pri-group timeslots 1-24 service mgcp
!
!
dial-peer voice 4 pots
application mgcpapp
direct-inward-dial
port1/0:23
 
found my answer..

incase anyone is wondering.. the answer is NO

if you running h.323, you can block incoming numbers based on CLID. running MGCP on the gateway will not work.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top