bullitrider
Technical User
Hi, i got a CCM3.3 with PRIs on a 3725gw and i want to block a certain phone number from entering the CCM. MGCP is enable and i'm wondering if i were to use dial-peer commands below, will it work? I'm thinking not, because of MGCP is taking over the PRI
voice translation-rule 1
rule 1 reject /6045551212/ <<<<-------- filter out calls
voice translation-profile reject_ANI
translate calling 1
dial-peer voice 4 pots (make it the same as my current)
destination-pattern 9T
direct-inward-dial
port 1/0:23
call-block translation-profile incoming reject_ANI
call-block disconnect-cause incoming user-busy
________________
what's config on the GW
ccm-manager mgcp
ccm-manager config server x.x.x.x
!
voice-port 1/0:23
!
Controller t1 1/0
framing esf
linecode b8zs
pri-group timeslots 1-24 service mgcp
!
!
dial-peer voice 4 pots
application mgcpapp
direct-inward-dial
port1/0:23
voice translation-rule 1
rule 1 reject /6045551212/ <<<<-------- filter out calls
voice translation-profile reject_ANI
translate calling 1
dial-peer voice 4 pots (make it the same as my current)
destination-pattern 9T
direct-inward-dial
port 1/0:23
call-block translation-profile incoming reject_ANI
call-block disconnect-cause incoming user-busy
________________
what's config on the GW
ccm-manager mgcp
ccm-manager config server x.x.x.x
!
voice-port 1/0:23
!
Controller t1 1/0
framing esf
linecode b8zs
pri-group timeslots 1-24 service mgcp
!
!
dial-peer voice 4 pots
application mgcpapp
direct-inward-dial
port1/0:23