Block Incoming Nuisance Calls 4

[apersoncalledsmit]

Hi,

Does anyone know a way to stop an incoming nuisance call on an IP Office 500?

I have setup a new incoming call route with the Incoming CLI set to the number I wish to block. I have then set the destination as a shortcode that Clears the call.

This works ok for the main number but does not apply to all the DDI’s setup with other incoming call routes.

Does anyone know of an easy way to set this up or does an additional incoming call route have to be added for each DDI setup?

Thanks for your help.

 

[TomMills]

set the incoming number field as a *

http://www.twitter.com/tem1985

ACSS-SME
fo shizzle ma nizzle.

 

[tlpeter]

Instead of using the DDI number, use a * as a wildcard.
This then applies to every DDI you have

Homo sapiens non urinat in ventum

honey, i fried the IP Office !!!

A yard full of tards

 

[TomMills]

too slow old man

http://www.twitter.com/tem1985

ACSS-SME
fo shizzle ma nizzle.

 

[tlpeter]

I am getting old indeed


Homo sapiens non urinat in ventum

honey, i fried the IP Office !!!

A yard full of tards

 

[apersoncalledsmit]

Thank you both for your help, works great.

 

[TomMills]

happy to have helped.

I guess age=experience tlpeter.

http://www.twitter.com/tem1985

ACSS-SME
fo shizzle ma nizzle.

 

[tlpeter]

They say so but you forget things much quicker too.
I am not sure if that is bad or good


Homo sapiens non urinat in ventum

honey, i fried the IP Office !!!

A yard full of tards