Sorry for the simple question...
I can't find where to modify the paste board size so I can extend my bleed of the page 0.875". Currently, when you create a page in Quark 4.1, it gives you approximately 0.5" on top and bottom to extend your print job paste the page size and several inches on either side.
The print company's specs require 0.875" top and bottom. Is there a way to do this without creating a page the size including the bleed size and placing my own registration/crop marks?
Bob
I can't find where to modify the paste board size so I can extend my bleed of the page 0.875". Currently, when you create a page in Quark 4.1, it gives you approximately 0.5" on top and bottom to extend your print job paste the page size and several inches on either side.
The print company's specs require 0.875" top and bottom. Is there a way to do this without creating a page the size including the bleed size and placing my own registration/crop marks?
Bob