fourofclubs
Programmer
G'day,
I've got a rather odd problem involving printing reports. I'm adding a record to a table and updating it, then trying to print a report based on the new record. Should be simple. However, I seem to be getting a few blank reports mingled in with the proper reports. I've checked out the table, and the record it uses is in there, so I don't think it's a problem with the table update. Funny thing is, if I print the same report twice, just repeating the same line of code, it'll sometimes print a blank report followed by a data filled report. The only thing I can think of is that the table update takes a while, and that the report is printed before the table is finished updating.
Any thoughts on this would be greatly appreciated.
Thanks,
Brad.
I've got a rather odd problem involving printing reports. I'm adding a record to a table and updating it, then trying to print a report based on the new record. Should be simple. However, I seem to be getting a few blank reports mingled in with the proper reports. I've checked out the table, and the record it uses is in there, so I don't think it's a problem with the table update. Funny thing is, if I print the same report twice, just repeating the same line of code, it'll sometimes print a blank report followed by a data filled report. The only thing I can think of is that the table update takes a while, and that the report is printed before the table is finished updating.
Any thoughts on this would be greatly appreciated.
Thanks,
Brad.