Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Blank page loads

Status
Not open for further replies.

retiring

MIS
Jul 3, 2002
35
US
I just set up a new machine and I am having this problem:

On about a third of the sites I try to load there is a flash on the status and "done" appears in the left hand corner but no page is loaded. In about half of these cases I get to the sites home page but get these results trying to navigate futher.

Am I missing something. Using ie 6

Thanks for your help
 
Thanks bcastner.

xp 2003 sp2, Brand new machine. It may be my ISP. Yesterday they were dropping me after about 45 minutes with no disconnect message which has never happened with them before. I am going to check with them on Monday.

Regards
Bob
 
If using DSL, it is important to get the MTU value set correctly.

For ADSL 1492 is the most common MTU, but test it:

. If you are using a Broadband router, use its configuration pages to set the MTU value you discovered above.

. Then set all client MTUs. The DrTCP utility makes this easy enough to do:
Finally, this might be a secure site issue:
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top