Roadkill150
Programmer
Hello All,
Perhaps someone has run into this before and has the solution. I have a very simple report that I've created with a report header and detail section showing, nothing else. Basically I have a number parameter that the user will enter a number that will limit the number of pages displayed.. A simple formula of : {?page}<=PageNumber is placed in the section expert detail portion. The correct number of pages shows with data, but there is always an extra page following that is blank. I've made sure that "keep together" is checked off, and that all sections are suppressed except for the report header and detail section. Any input on this would be appreciated! It sounds like i am missing something small here.
Thanks! Seagate Certified RCAD Specialist.
-Bruce Thuel-Chassaigne
roadkill150@hotmail.com
Perhaps someone has run into this before and has the solution. I have a very simple report that I've created with a report header and detail section showing, nothing else. Basically I have a number parameter that the user will enter a number that will limit the number of pages displayed.. A simple formula of : {?page}<=PageNumber is placed in the section expert detail portion. The correct number of pages shows with data, but there is always an extra page following that is blank. I've made sure that "keep together" is checked off, and that all sections are suppressed except for the report header and detail section. Any input on this would be appreciated! It sounds like i am missing something small here.
Thanks! Seagate Certified RCAD Specialist.
-Bruce Thuel-Chassaigne
roadkill150@hotmail.com