BIG PROBLEM...NEED HELP...

[klobo100]

We have very interesting problem.An end exchange MD110 is connected through IPLU board to the other MD110 who is transit exchange. That transit MD110 is connected to public exchange AXE10 through 2Mbit/s old e1 . When end exchange try to make public call ,
phone call is realize but no audibility between A and B side.
When same call is tried through that transit MD110, everything is ok.
I have two IPLU boards, and the same thing happens to both.

END MD110 EXCHANGE

<RODDPEST=83940,IPOPT=YES;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST IP ADDRESS RROUID
83940 100 10.190.70.202

<RODDPEST=83940;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
83940 100 000500000000025000000000000 0 1 0

<RINIP:LIM=ALL;
IP NETWORK INTERFACE DATA
BPOS GRP IP ADDRESS MASK ROUTER ETHCNF VLAN SILDET
1-0-50 1 10.190.28.202 255.255.255.0 10.190.28.1 0 H'FFFF 1

TRANSIT MD110 EXCHANGE

<RODDPEST=83940;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
83940 40 044600000000025000400101000 0 6 0

<RODAP:ROU=40;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
40 SL60 H'00000210 H'11400000 H'06410020 NO

END

<ROCAP:ROU=40;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
40 0120000011000010 5 0001000001 0 30 128 01151515 211110000030 111111


<RINIP:LIM=ALL;
IP NETWORK INTERFACE DATA
BPOS GRP IP ADDRESS MASK ROUTER ETHCNF VLAN SILDET
1-0-40 1 10.190.70.202 255.255.255.0 10.190.70.1 0 H'FFFF 1
5-0-50 1 10.190.70.203 255.255.255.0 10.190.70.1 0 H'FFFF 1

PLEASE HELP

 

[rfpup]

Hello,

If you have not changed anything before the problem appeared try to reset each of the IPLU-s

 

[fcpli]

Pls send proper data roddp, roddp:ipopt=yes, rianp, rinip, rocap, rodap from
1) End MD
2) receiving (transit) MD (not outgoing E1)
Your printouts are a little bit confusing
Is it possible to call from end MD to transit MD?

 

[klobo100]

thanx for replay,

problem is solved

ON END EXCHANGE IT MUST SET PARNUM 74 TU VALUE 20, TILL NOW IT WAS 30

ASPACARNUM=74,PARVAL=20;

NOW THE CALLS ARE OK...Operator change something , update or something like that, so we have to adoptated our exchange sistem.

regards