I just completely reinstalled BE 8.5 from scratch. The software is running an ATL p1000 tape robot with 4 drives. When I try to run an inventory I get an error because a tape is already in one of the drives, the robot doesn't recognize it, so it disables it. This happens to all but "one" of the drives. The job fails and in the log it says "changer error, device is busy" about a dozen times. It appears that about 1 or 2 tapes actually gets inventoried but I've got about 20 in the robot and the tapes drives keep getting disabled.
So far I've:
1) Uninstalled BE and reinstalled BE completely. (beforehand I uninstalled the hardware via add/remove hardware menu.
2) Updated the device drivers from Veritas.
I'm sure this a tape robot problem but I'm out of answers here. Any ideas? Thanks.
So far I've:
1) Uninstalled BE and reinstalled BE completely. (beforehand I uninstalled the hardware via add/remove hardware menu.
2) Updated the device drivers from Veritas.
I'm sure this a tape robot problem but I'm out of answers here. Any ideas? Thanks.