BCMS naming services error

[phoneuser]

we are installing BCMS2 and are getting an error or actully
it just stuck "trying to locate naming service"

added server as bcmsserver in lower case as it
is the name of the PC Machine

we are using the usb superpro dongle ....loaded the drivers
now seeing usb superpro .....loaded bcms server on PC
no longer getting "can not see hardware error" after restarting the Server .....running
XP Professional
Version 2002
Service Pack 2

any thoughts ?? Thank You for any and all posts
I have done a couple of installs but ist been about 2
years ....trying to remember

Phoneuser

 

[phoneuser]

correction name of Machine is bcmrserver

 

[phoneuser]

I ended up reloading everything as it seems not not have seen the usb key again ...giving errors ....now I can see
everthing ...setting up the connection to the server using 8400 data module did the following commands through
hyper-terminal :

at
at&f (defualts unit)
ats24?
ats24=001
at&w0
at&y0

I have setup the login and password in the PBX
I can login from the SAT terminal with them but not the
8400 using com port 1 to the data module when trying the test it fails ...I see it flash green (led on 8400) for about 2-4 seconds ...its calling the Netcon Hg in the switch any other thoughts ???

Phoneuser

 

[phoneuser]

doing an at&v command shows the following setup in the 8400

at
OK
at&v
ACTIVE PROFILE:
B1 E1 L2 M0 Q0 V1 X4 Y0 &C1 &D2 &G0 &J0 &L0 &P0 &Q0 &R0 &S0 &X0 &Y0
S00:000 S01:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:030
S08:002 S09:006 S10:014 S12:050 S14:AAH S16:00H S18:000 S21:30H
S22:72H S23:1BH S24:01H S25:005 S26:001 S27:40H

STORED PROFILE 0:
B1 E1 L2 M1 Q0 V1 X4 Y0 &C0 &D0 &G0 &J0 &L0 &P0 &Q0 &R0 &S0 &X0
S00:000 S14:AAH S18:000 S21:00H S22:76H S23:1BH S24:01H S25:005
S26:001 S27:40H

STORED PROFILE 1:
B1 E1 L2 M1 Q0 V1 X4 Y0 &C0 &D0 &G0 &J0 &L0 &P0 &Q0 &R0 &S0 &X0
S00:000 S14:AAH S18:000 S21:00H S22:76H S23:1BH S24:01H S25:005
S26:001 S27:40H

TELEPHONE NUMBERS:
&Z0=
&Z1=
&Z2=
&Z3=

 

[phoneuser]

I ended up powering down the unit twice after doing the above at commands ....I thought that this stored the commands ....but the end result is that I could get into the switch .....cheers

Phoneuser