BCM50 with DID's on MPLS routed to remote location

[PDL123]

I have a customer with 3 locations. Their carrier (XO) has installed a MPLS circuit at the main location which carries all of the DID's for the 3 locations. I have set up 4 digit dialing between the locations and that is working well, although when I program a target line on one of the remote sets to receive the DID digits it rings to receptionist. I set the target line as DN and the receive digits to private receive. Please Advise.

Thanks,

PDL

 

[norstarboy125]

Do you have MCDN keycodes installed in the BCM's?
Are they all on the same release?

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[PDL123]

I don't think that they have the keycodes I will have to check. They are not all on the same release.

Thanks,

PDL

 

[telcodog]

If you don't have MCDN then you have to use the Public Received digits in the target lines to direct the calls.