Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BCM50 Telset and VM programming

Status
Not open for further replies.

hawkflorida

Technical User
Mar 5, 2002
205
US
I can get into KSU programming via the Telset just fine but fail to connect to the Voicemail using the Telset. After F983 you see LOG and I enter the normal log mailbox password combination. The you are prompted for password. I am entering the telset password and the response is "invalid password". Any ideas would be helpful.
Thanks

Consulting -
"If You're Not A Part Of The Solution, There's Good Money To Be Made In Prolonging The Problem."
 
Are you using the default telset admin user ID (i.e. 738662) as the log?

 
After F983 you are prompted for by LOG...and then after that you are prompted for the PASSWORD. The password I am using is the telset pw. For the log I'm not sure what to use but have tried the SM mailbox/password combination. What do you use?

Consulting -
"If You're Not A Part Of The Solution, There's Good Money To Be Made In Prolonging The Problem."
 
Thanks for sharing the information kh3572. That's what makes this site so great, the help that is offered. I had looked in the Telset manual but couldn't find it the entries spelled out.

Thank you again.


Consulting -
"If You're Not A Part Of The Solution, There's Good Money To Be Made In Prolonging The Problem."
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top