BCM50 PRI E1 EURO

[actec]

Hello everybody.
I have a big problem, I need to configure an interface E1, PRI EURO standard, the BCM50 here in Brazil, I have not the slightest knowledge for that.
Already installed in the expansion module 2, the same synchronized with the telecom and receive calls as usual.
What I can not do is set up so that the extensions can also access lines and dial out.
And also direct incoming connections from certain numbers to certain extensions (DDR)
Thanks for the help, step by step ....

 

[norstarboy125]

You just said it all, YOU HAVE NO KNOWLEDGE AT ALL. I would make life easy for yourself buddy and call a local vendor that has a good idea how to program your system. This isn't something that you can just wing believe me.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[actec]

I know it was the right thing to do, but here in Brazil things are not that easy.
See what to buy this interface had to import from Mexico.
Resellers charge here besides the nonsense interface, no one wanted the responsibility to install, only supply.
So look for installation help.
Unfortunately the reality is here ...
I know the BCM50, but this is my first installation of an E1.
Thank you ....

 

[norstarboy125]

If you know the BCM programming then start with your basics like making sure that the exp cabinet is set up with proper module type, program your lines to be in a pool with a dest. code for outgoing calls. You will also have to set up target lines with proper received digits for incoming calls.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[actec]

Thank you for helping Norstarboy
I'll describe what I did:
1 - The BCM50 this reset, configured for country: BRAZIL - START DN: 4000
2 - I installed the module in the 1st cabinet, he is using the bus 5, recognizes the module as PRI - Type EURO - 30 channels - Line 65-94 - Pool Lines: BLOCO_B
3 - The module is synchronized with the provider, there is no indication of errors in the interface the BCM50, the logs are OK.
4 - Without configuring anything on the BCM50 can receive calls at E1.
5 - I need to configure extensions to make calls out.
Could you help me with this?
What would be the next step?

I saw that you are part of a company that sells equipment and services.
You would like to provide licenses for this BCM50?


Jose Aranha
ACTEC Network

 

[norstarboy125]

I can help you, contact me via email off website.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[actec]

Ok
For your website?
Either?