BCM50/FreePBX integration Sip or H.323

[AShammah]

Hey all,

I'm trying to connect a BCM50 to a FreePBX instance via sip or H.323. So I can get SIP phone functionality on the BCM50 for Sip Video doorbells.
I'm looking to get the doorphones on the freepbx to ring the current doorphone hunt group 474 on the BCM.

When I try to connect sip BCM says "forbidden from 192.168.1.245:5060" which is the FreePBX.

H.323 is setup but doesnt seem to work.

Hitting the doorphone button set to call 474 I get a Freepbx message "all circuits are busy now, try your call again later"
Dial pattern is set to X. on sip and H323/192.168.3.2/${EXTEN} on H.323 on the Freepbx.

 

[AShammah]

This is how I have my target lines setup:
Voip.ms trunk calls coming in on Target lines 125-127 get routed to separate IVR's then to the appropriate extension or hunt group.
Calls coming in from freePBX target lines 128-129 are added to the current BST doorphone hunt group 474 set to ring broadcast on all extensions.

So I would need to create an extension for each door phone or any other type of phone thats on the freepbx in the BCM and set the target line as that DN # under line type to get BCM dial tone.


Yeah I was thinking that would work Hik - Panasonic

 

[AShammah]

@daniel05

I cant get freepbx to register with the nortel using your settings.

I get not found from 192.168.1.245:5060 which is the FreePBX

 

[daniel0581]

@AShammah can you post a screenshot of the FreePBX trunk settings?

 

[AShammah]

I have my dial patterns set up as 2xxx for BCM digital, 3xxx BCM IP Phones, 4xxx BCM hunt groups


I tried using Outbound, Inbound, Send & receive. I still get not found from 192.168.1.245:5060 on the BCM

 

[AShammah]

Got the trunk registered . Doorphones work perfect
I had it calling BCM-FreePBX when it was on "Public" using 89 to dial to FreePBX. I removed the public now I have "89" as dest digits in the private routing table it doesnt call out to the FreePBX.
I also still don't understand how to set DN's in target lines to give FreePBX extensions BCM dial tone so they can access BCM Line pools *codes ect.
I have a few 8865 Cisco's I'm going to convert to MPP. I'd like to see if they display the Hikvision Doorphone video feed on a call.