BCM50 and 12004 with Key Expansion Unit?

[george66]

I can't figure out how to program this ... the KEM light up OK, but there seems to be no way to program the buttons in Element Manager. The general Nortel documentation on IP phones shows something about programming the KEM in "LD 11", but I have not a clue what "LD 11" is. Can anyone help? Thanks.

 

[Justatec]

I think you need a key code in the 50s key code for evey thing...

 

[george66]

Sorry, the title should say "i2004", not 12004....


I don't understand your comment about the key code ... the digital phones handle 7 call appearances presently ... do you think there is a special keycode to do >4 call appearances on the IP phones?

 

[steeef]

this is no keycode thing. The IP-KEM is not supported in BCM50 R1

 

[george66]

steef -

Thanks for your response. Perhaps I could just use two IP phones, each with call appearances for 4 of the lines. Would that work?

 

[steeef]

never tried that, but should work...

 

[gecko202002]

FYI - LD 11 is a telephone programming load in a Meridian switch.

 

[biv343]

KEM will work in BCM 50 R2 and BCM 200/400 release 4.

Sure has taken them long enough to get that feature built into the BCM.

 

[senk1s]

yep at this time it is only for the CS systems