BCM450 - PRI with 2 DTMs

[wanderin]

Can't get PRIs to work.

GASM in slot 1,
DTMs in slots 3 & 4,
60 IP sets,
capacity exp card.

Telco has 5ESS, looking for and configured for NI2, B8ZS and ESF. Can't get both D channels to enabled status as shown in Administration>Telephony Metrics>Trunk Module Metrics>D Channel.

PRIs work on existing G3.

 

[nooop]

What about configuration_resources_telephony, are they set properly there? What does not work, inbound, or outbound? Are Target lines built? Do you have routes? How do you plan to bond the 2 PRI's, or will they each use a different route?

 

[cook1082]

They need 2 seperate d channels, wont work with 1 for the 2 pris.