BCM400 Rls.3.6(Fully Patched) 1way audio on IP set

[JBinSanD]

Hope someone can help.

I have the above mentioned BCM. I have one i2004. It registers and works, except for a one way audio issue. I have tried three sets total with the same results.

I can make/recieve a call at the set, the other party(internal/external) can hear me on the IP set, yet I get no DT or audio from the caller. I do however hear the set generated blips related by key presses.

To rule out any network issues, I have gone as far as connecting the device DIRECTLY to the 2nd NIC using a X-over cable; obtaining the same results.

 

[acewarlock]

QUOTE:
I have gone as far as hooking directly to the second NIC with a X-over cable with the same results

I don't think You would use a crossover cable.




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.

 

[JBinSanD]

K-

Yep...think so too.

Ace-

FYI- Yes, the X-over direct does work(not on this one of course) I have done it in the past to rule out any network issues.

 

[acewarlock]

Is the Published IP set correctly to the Right LAN?




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.