BCM400 outbound call routing rules 1

[pleskuk]

Hi guys,

I have a BCM400 system in-house and I'm facing some challenges to configure outbound call routing rules but because of my limited knowledge about BCM it would be great if you could point me how to fulfill this task.

At the moment I have one active ISDN PRI trunk with local telco through which all my inbound/outbound traffic goes. Management asked to deploy additional ISDN BRI board (which I have already installed and connect GSM adapters/gateways to it) and to route specific destinations through this trunk. The idea is all traffic should go through the ISDN PRI trunk except the numbers which start with 05 (which is mobile network) which should go through the ISDN BRI board which has GSM adapters connected to it.

Any ideas how to complete this topic?

Thanks in advance.

Cheers,
Ivo

 

[pleskuk]

Oh and Merry Christmas, best wishes and many returns to all of us

Cheers,
Ivo

 

[allworxguy]

All you need do is create a route for the new BRI and a destination code that points to it.

I also suggest you create a restriction for 05 and apply that to the PRI to stop users from dialing 05 on the PRI

Marv ccna

http://www.telemarv.ca

Sales, Installation & Service for Norstar, BCM, Samsung & Allworx Serving Ottawa and Eastern Ontario since 1990