Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BCM400 CLID

Status
Not open for further replies.

dan5800

Technical User
Aug 7, 2007
5
CA
Simple BCM 4.0 system with Centrex lines. I am getting intermittant caller id on inbound calls. Installed 2 weeks ago with up to date patches and all lines were initally good. After 3 days it started with 1 phone not receiving on their private line. (any transferred calls are ok) Now it is up to 4 lines. The lines are also on different cards. Monitor is not showing a number when called so I checked at the frame with an analog display set and the CO is sending the number. I didn't see anything on Nortel site for this problem. Maybe a reboot is in order. Any ideas?
 
Sounds like the users may be answering too quick. Try doing a F811 when they're on the call to see if the info was captured. Users have to wait until at least the start of the second ring cycle to ensure the system has time to capture and proces the clid info.
 
Thanks, I did try up to 4 rings and no info appears. F811 also shows no info. Strange one...will try a reboot over the weekend.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top