Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BCM200 telset login

Status
Not open for further replies.

kpzan

Technical User
May 14, 2016
173
US
Hello, got a question about BCM200 3.5.

Can the BCM200 3.5 be programmed through a phone set?

I try to enter programming using the same method I use on BCM50s and it doesn't work.

Maybe the original installer disabled the telset programming interface?


Thanks in advance.
 
Telset not supported, there is a backdoor way for support using F**system.
Cannot post passwords.

This method is not supported and believed to cause corruption when using it.



________________________________________
small-logo-sig.png


=----(((((((((()----=
Toronto, Canada

Add me to LinkedIN
 
As Curly has stated, It was never recommended that you programmed via the Telset, although I used to do it a few times. The main thing to remember is that you could only access the same sort of areas that were available on the Norstar range and anything IP related wasn't accessible. You needed to use a M7316 or a larger set to access the programming area.

Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website = linkedin
 
Thanks. Didn't know telset programming could cause corruptions. It's handy for making small changes.
 
I never had any problems using F**SYSTEM on the old BCMs, but your mileage might vary. I remember that corruption could occur if someone was logged into the BCM Unified Manager at the same time. Like David wrote, confine yourself to the Norstar type programming areas when logged into a telset and you should be OK.

Brian Cox
Georgia Telephone
 
Thank you gentlemen for the explanations. I didn't know F**SYSTEM existed. Your sharing of Nortel knowledge is greatly appreciated.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top