BCM

[robweston4563]

Can someone advise me

how to remove ALL of the following:

Target Lines
Voip Lines
Hunt Groups

basically, I need the system to see the lines attached to the GATM module, and lines to ring at the switchboard.
At the moment we seem to have a lot of other lines, that are not on the system, but they are on programming, and when a call comes in nothing rings, due to the settings put in for the other lines.

It would be ideal if we could start from scratch, but we would need to keep the feature keys purchased. any ideas?

 

[norstarboy125]

Sounds like it might be best to perform a restart of the system and start from scratch.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[robweston4563]

Ok... how od i do that and save all the keycodes ?

 

[phoneguy610]

you need to either have a copy of the orginal lic file or have one regenerated from krs

ddcommllc.com
Avaya/Toshiba/SyntelSolutions

ACIS

"Will work for stars

 

[exsmogger]

I'm fairly certain you can do a STARTUP through the telephone interface without losing your keycodes. This can only be done within 15 minutes of powering on. If this is wrong please advise.

Brian Cox
Georgia Telephone

http://Georgia-Telephone.com

http://www.linkedin.com/in/briancox1952

 

[snowman50]

Do a cold telephony reset
This will erase all PBX programming and voicemail.

Then you re ready to go