BCM to BCM ?

[blk01s4]

I have two BCMs one in Ohio BCM A (Extensions 4000-4040) one in Miami BCM B (Extensions 3221-3235) the have the following setup so far:

BCM A & B have a Digital Trunk Interface card with a T1 Crossover going to a VOICE compression card to a Cisco 2811. BCMs see that as a PRI (24 chans). The BCM is also equiped with the standard Dual LAN interfaces. Also, BCM A & B use Digital handsets T7316e, no IP phones, no WAN interface either. I want to do private dialing between the two BCMs, create a trunk? I have the manual printed out and following their instructions but I just get a fast busy. I have a private IP address set on LAN2 on both BCMs, "Published IP Adddress: IP-LAN2" is set since I set the Public ip address on that interface. I can ping both Public addresses on BCM just fine .. How do I configure the BCM to push private calling over the LAN interface instead of the Digital interface .. I think thats my problem .. Any ideas?

 

[blk01s4]

Public IP not Private IP sorry .. /29 address.

 

[1tech]

you need ip trunk license

 

[blk01s4]

Total trunk credits" 4 .. Is what I have .. Isn't that a trunk license?

 

[blk01s4]

OK now it works , sip configured correctly. Except now all calls are going to PUBLIC instead of PRIVATE digits.

 

[acewarlock]

You should post this in the BCM Forum #1361, you might get better answers.