It depends if the received digit length is public or private.
My guess is that you need to log in via the Element Manager tool and navigate to the Telephony folder. Then look for the Dialing Plan folder. Look for the public and private tabs. in there are the individual received number length and you will need to just increase it to "4".
9 is probably already in use such as to dial out via External code 9, Pool code 9 or Destination code 9.
0 is in use to dial the main set (Direct Dial).
You could ask the carrier to send 10 digits then just find the digit you can use and then change the received digits to that.
It is of for carrier to send more than what you program.
OK - that helps me. I have changed the Received number length to 7 under dialing plan. I've entered the phone number under target line 361 and added set 225 as control, prime and as assigned dn. What I do not see is how to "connect" the target line to my PRI (lines 017-039). PRI is working for outbound calls - need to test inbound.
You assign "lines to sets", not "lines to lines".
Once you have programmed the Received Digits for each DID/Target then go into Sets/LineAccess/Line Assignment and assign the line number (Target line).
Best to assign as Ring Only and assign 2 Intercom keys.
"Received number length to 7 under dialing plan"
Did you first verify that the carrier is sending 7 or more digits to you?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.