BCM 4X16 Module

[MikeH1]

Im having trouble getting the bcm to see the trunk portion of the 4x16 module.Ive taken it out and reset the dipswitches,enabled and disabled bus 1 and 2.My station portion is working just fine..Any clues????? Thanks Mike

 

[biv343]

If it's at the default dip switch settings (all on), the trunks will be on bus 2 and the stations will be on bus three. The programming for bus 2 defaults to T-1 - you'll need to reprogram bus 2 as a loop start analog trunk card.

 

[Justatec]

What else do you have,that 4x16 card,screws up every thing
What do you have in the system as far as card and settings.

 

[Justatec]

No,,, I like the card,it makes you think.

 

[MikeH1]

I reset all the dip switches,Rebooted the system,and checked all the configs...It will not recognize the truck module in config under resourses.Is there a way to default the whole system???? It doesnt matter if I lose all the programing because Im just learning as I go and it is not at a customers premise.It does recognize the staion part of the module..There is no other cards or modules on the system.I do have 2 seats for voip...Thanks Mike

 

[MikeH1]

Hey Thanks everybody for the help.The crazy thing just started working!!!?????
I did some more programming changes and evrything seems fine.... Who'd a thunk it !!!!