Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BCM 450 Rel. 5.0 with FEM to connect Norstar DTI card

Status
Not open for further replies.

masterjim

Technical User
Jul 18, 2006
38
US
Hi All,

We have installed only a few BCM 450s so far and have not yet used an FEM.
We have a customer with a fully expanded MICS, including a DTI card, who would like to migrate to a BCM 450 Rel. 5.0.

Page 34 of the BCM 450 Rel. 1.0 Installation-Devices manual states the following:

"Clock source... ISDN interfaces must synchronize clocking with the ISDN network and any ISDN terminal equipment connected to the network...
Clock synchronization is supported by the DTM, BRI module, and FEM."

The Task Based Guides for the BCM 450 Rel. 5.0 (p. 21 of the Installation, Hardware, MBMs) mention the configurability of only BRI cards.

"Configuring the Fibre Expansion Module
The Fibre Expansion Module (FEM) has a slightly different – but not inconsistent – configuration method.
Up to 6 Norstar Expansion Modules can be connected to the BCM450 via the FEM.
Each Norstar Expansion Module will need to be configured individually in Telephony Resources...
The available Configured Device types for the Norstar Expansion Modules within Telephony Resources are as follows:
Norstar TM (Trunk Module) – Norstar Global Line Module containing Analog or BRI cards"

So, can I use an FEM in the main cabinet of a BCM 450 Rel. 5.0 to connect a Fiber Trunk Module containing a Norstar DTI card to support a PRI circuit?

Thanks in advance for any help.
-Jim
 
I don't think so because to use a DTI card in a Norstar Module you would need a Clocking card - Combo/ services card and the DTI cards in the BCM provide their out clock source.
 
Thanks for the reply.

So, what does the above comment: "Clock synchronization is supported by the DTM, BRI module, and FEM" refer to?

-Jim
 
I found this in the 4.0 I&M guide.

The following table provides a cross-reference between market profiles and the Norstar
trunk cartridges you can connect to the FEM.
BRI S/T 2/4 BRI U2/4 Analog DID Analog E&M
Analog
CLID.

No DTI.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top