Have a 450, Rls 6. Installed the keycode for RAID. Loaded the R6 Factory Image patch. Installed the drive, enabled RAID. Rebooted, but still will not recognize the 2nd drive. I have Green, Red, Red LEDs. Tried another brand new drive, no change. The docs just say plug it in, enable and when it reboots, it will start mirroring. Am I missing something?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BCM 450 RAID
- Thread starter hototot
- Start date
is the main drive in the left slot and raid drive in the right slot
For RAID enabled systems, i.e. supporting a secondary hard drive, you can check which hard drive has failed. In the Element Manager Administration tab, open the System Metrics folder and click on Disk Mirroring. If either drive is listed as Failed or not listed at all (e.g. the system may have been rebooted after an earlier failure) that drive will need replacing
For RAID enabled systems, i.e. supporting a secondary hard drive, you can check which hard drive has failed. In the Element Manager Administration tab, open the System Metrics folder and click on Disk Mirroring. If either drive is listed as Failed or not listed at all (e.g. the system may have been rebooted after an earlier failure) that drive will need replacing
- Thread starter
- #3
Latest SU patch will fix this. There was a problem with the original image load. Only other way I've found to make it work is to image the mirror drive the same as the main drive--apparently once the drive has the correct partitions, RAID will work.
- Thread starter
- #5
- Thread starter
- #6
- Status
Similar threads
- Locked
- Question
- Locked
- Question
