BCM 450 R1 not working after replacing Hard drive & Power supp 1

[SoCalTek]

Ok, So the symptoms have beeen from the begining the same... once i changed the Hard Drive and Power Supply for BCM 450 r1. this unit has been installed only for 3 years. Only IP phones exsist on system and 2 Pri's.

Status light on the unit Blinks Yellow or orange cant really tell because it doesnt look so great. but it does blink.
Solid Green on Power and
Solid Green on HDD-1,
my DTI cards look like a damn Xmas tree, like when you begin to program on them. I Cant even get into the BCM Via OAM Port or Network port or for that fact even COM port... But i can ping the unit at 10.10.11.1... WTF....

Whats next, Base Tray, MSC Card ... Or Boat anchor.... Help!!

Anybody seen any issues like this before..

I pressed the reset button on the front for less than 5 seconds, still no love...

 

[telcodog]

I have......turned out to be the Base Function Tray in 3 different cases. Never did see it again in subsequent releases though. Seeing that you've already replaced the other major components, it's worth a try. Your hard drive is probably ok so all you should have to do is migrate your licenses and you should be good to go.

Good Luck.

 

[pccal]

What type of drive did you replace it with? If it is a newer Multi -Image drive you have to Putty into 10.10.11.1 & choose R1,5 or 6 image.

 

[curlycord]

See this post:

http://www.tek-tips.com/viewthread.cfm?qid=1676291

What is your status?

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[SoCalTek]

Thanks Curly cord, i forgot to Serial cable the Darn thing.. it was a multi Ver Harddrive... Thanks Again