Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BCM 450 new install
- Thread starter jimmer911
- Start date
Firebird Scrambler
Systems Engineer
I seem to recall that you need to look via the BCM Element Manager Application or Telephony Resources etc to the area that shows you the BCM Bus sections as there should be some dip switch settings that you will need to make a note of in order to apply in to your BCM DTM module.
You may also need to disable the module and then enable it again. I'm not sure if I have attached the correct help file.
Firebird Scrambler
Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer
Website =
You may also need to disable the module and then enable it again. I'm not sure if I have attached the correct help file.
Firebird Scrambler
Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer
Website =
number1telecom
Vendor
A good old fashioned reboot has never hurt when I've had weird things happen trying to enable modules.
Also.. The cable is supposed to be 16.4 feet.
Also.. The cable is supposed to be 16.4 feet.
- Thread starter
- #4
curlycord
Programmer
You did not say if you did but in resources under expansion X did you select the drop down under configured device and select the appropriate MBM?
Did you also connect a phone to any one of the ports?
________________________________________
Add me to LinkedIN
=----(((((((((()----=
Toronto Canada
Did you also connect a phone to any one of the ports?
________________________________________
Add me to LinkedIN
=----(((((((((()----=
Toronto Canada
- Thread starter
- #6
- Thread starter
- #8
- Status
Similar threads
- Locked
- Question
- Locked
- Question