BCM 450 Expansion location units, how are they assigned?

[Beauty1982]

Hi folks:

I'm installing a BCM 450 with an expansion module; but fist I have to configure the MBM in the BCM Manager, then plug in, but in the expansion I see 6 slots and I do not how they are assigned.
I'm supposing they star as the main, right down to up.

Can you give me a hand?

Thanks in advance.

 

[mando1]

They start at the lower right hand side and go up.

6 3
5 2
4 1

 

[Beauty1982]

Thanks mando1, I really appreciate your help

 

[bluemr2]

I don't believe that is correct. Their is no order in the expansion cabinet. It all depends on the dip switch settings.

 

[Dasheen]

blue is correct

 

[telcodog]

All you have to do is assign the module type under BUS6 under the resources tab and it will tell you how to set the dip switches. After that, you can plug it into any slot in the expansion cabinet you want.

 

[morgans12]

Make sure you have purchased and installed the Exp cabinet keycode