bcm 400, trying to assign a line to a DN, where one would set appearance type, appearances and caller ID set, the caller ID set box is grayed out and wont let me change it.
I've tried untying the line from the DN, restarting element manager, and even rebooting the bcm, but no dice on this particular dn/line pair
I've tied target lines to other DN's before and after without issue
Any suggestions?
I've tried untying the line from the DN, restarting element manager, and even rebooting the bcm, but no dice on this particular dn/line pair
I've tied target lines to other DN's before and after without issue
Any suggestions?