Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BCM 400 and BCM 50 1

Status
Not open for further replies.

Justatec

Technical User
Feb 25, 2005
319
US
I have one bcm 400 and two bcm 50s to install in 3 different locations, 4 digit dial is this the best to use,then three,They will be connected thought a 3.0 meg cable, I know routes and des codes need to be in place.Whats the best.. Thanks senk1
 
what's your question?
to route calls between them?
you do need to configure call-routing/scheduled-services/trunking.
 
If you'll have DID's on a PRI/T1 in the picture somewhere then 4 digit gives you less of a chance of conflict.

I prefer 4, especially if they might grow and add a site or two in the future. It's a lot easier to get them used to dialing 4 digits off the bat rather than be reprogramming 3 sites sometime in thr future.
 
Thanks biv343,yes
there will be other locations.

Thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top