BCM 200 DSM 32+

[Allen1]

I was working on a BCM 200 3.7 s/w and lost the 1st 16 ports on the lower amphenol on Bus 02. The other 16 ports work correctly and display the proper extension numbers and ports. The sets flash but never set up on ports 201 -216.
I reset the dip switches to Bus 03 and both amphenols work properly on the same DSM 32+. How can I recover ports 201 - 216 on Bus 02?
Any help would be appreciated.

 

[pccal]

What happens if you try to re-dip it for Bus 2?
If it doesn't work you could just do Dn. changes on Bus 3 if all you are worried about is keeping your Dn. numbers that were on 201 to 216.

 

[Allen1]

Thanks for your suggestion, however I found the problem to be a dip switch conflict on the GATM8 module that was causing the trouble.

 

[acewarlock]

You should set the GATM8 for BUS 6 or 7




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.