Basic 3620 setup

[vicbear13]

I have two 3620's and a 2950 and am trying to set them up just to be able to see each other. Did basic config using EIGRP. Both routers on same network connected FastEthernet ports via the switch. I think I am forgetting a step or a setting to get them up and this is where I am requiring help. Cant ping router to router, router to switch, switch to router, client to routers. Basically all I have done is:

EIGRP...both are on same AS and network
ports have IP's and are on
ports show up and up
switch shows ports up and up (connected)
nothing else on the LAN

Should I set up static routes?

Can someone provide some basics?

Thanx

 

[bbaruah]

EIGRP on ethernet ?!!!!!!!!

 

[dx1]

If both routers are on the same subnet, then should be able to see one another. Check your subnet mask. Also check the switch to see if there's any vlans setup.

Post your configs.