Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BARS AC1 Issue

Status
Not open for further replies.

NY105

Technical User
Jul 6, 2011
41
US
Hello out there,

I have a CS1000E that I am working on setting up BARS and the prevoius software programming is using SDGT under AC1. I need to remove these SDGT from AC1 and no where in the NTP's does it show how the remove these. Can anyone tell me how this done.

Thanks
 
Here is from memory. This is the ESN data print out from LD 86.

AC1 9
SDGT 0 OVF
SDGT 1 IMM
SDGT 2 PRY
SDGT 3 LOC
SDGT 4 RTN
SDGT 5 LOC
SDGT 8 LOC
SDGT 9 LOC
AC2
 
I'm not sure what you mean by SDGT. Where are you seeing this?
 
I see it right after the AC1 prompt in LD 86 ESN data block.
 

thread798-1657485

Either we need the Autovon book, or some old set of books, or which of the three letter codes sends the call out normally. You might not be able to remove these (just change them so they work)

Find more at GHTROUT.com
 
I don't see anything like this in the NTP's in LD 86. Must be some European software thing. Not sure.
 
We have found where to remove it. It was only visiable in Element manager under the ESN Data Block. GHTrout was right that is has to with Autovon. It is ols programming left over from a previous version.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top