Bandwith Restriction on FastEthernet Interface

[okanyilmaz]

I need to know if it is possible to restrict the outgoing traffic on fastethernet interface.

For several reasons outgoing traffic must be lowered to 6 Mbps on 100 Mbps interface.

Any help will be much appreciated.



Okan KANYILMAZ
okan_kanyilmaz@hotmail.com

 

[mainstreetexpress]

Hi
Use Cisco committed access rate

http://www.cisco.com/univercd/cc/td/doc/product/software/ios111/cc111/car.htm

 

[okanyilmaz]

Thank you, i've handled that with rate-limit command.

 

[KiscoKid]

CAR will do this but has been superceded now to be honest and you're kinda recommended to look at stuff like shaping or policing. Only difference between the 2 is that policing will drop traffic that is ouf of contract where shaping just buffers it.

The following URLs go into some detail about both the technologies above:

http://www.cisco.com/en/US/products...figuration_guide_chapter09186a00800bd8ef.html

http://www.cisco.com/en/US/products...figuration_guide_chapter09186a00804a27c4.html