Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bad Power Supply in an IP500V1 1

Status
Not open for further replies.

Justplainjo

IS-IT--Management
Apr 11, 2007
29
US
I have an IP500V1 with a bad power supply. I am trying to repair it, and possibly put in a power supply from a spare IP500V2 that i have.

For the most part they look identical; however the part number in the V1 is 46YPW0002UKAA and in the V2 it is 46YPW0002UKAB.

Anyone have any info on whether this will work or not, or whether there is a problem with putting this in?

Thanks,

Jo
ACSS
ICCS
 
I think the PSU in a v2 is better. Why not just send it to Multi message for a repair?

ACSS - SME
General Geek



1832163.png
 
Who is multi message, and how do i contact them?

 
I've seen a IP500v2 power supply work for a week in a V1 after a customer swapped it over. Told them not to do it and quoted a V2. Then was calling up for an emergency V2 when it went bang. Then they were left with two chassis that had no PS.

Don't do it pal.
It's not supposed to be serviceable.

Inter.bmp
 
the V2 power supply is in deed stronger than the V1 but North America did not have a lot of trouble with the power supplies breaking down because with 115V we put lower strain on it than the European 230V counterparts.
I would keep the V2 and send the V1 out for repair (and get it a year later back if you send it to Avaya, LOL) and then you keep it on the shelf for the next one.


Joe W.

FHandw, ACSS (SME), ACIS (SME)



Give a tech a solution and he will be back tomorrow to ask you the next question, teach a tech how to read the manual and he will be able to solve the problems for a life time.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top