hello,
it normally takes no more than 8 hours for a job i run every night. this morning, around 9:30 am, i found out that a job has been running since 9 pm last night and was at 13%. what could have caused the job to lag like this? one thing that i can think of is the scanning where you tell arcserve to scan every file during the backup process; where can go to check this option? thank you.
it normally takes no more than 8 hours for a job i run every night. this morning, around 9:30 am, i found out that a job has been running since 9 pm last night and was at 13%. what could have caused the job to lag like this? one thing that i can think of is the scanning where you tell arcserve to scan every file during the backup process; where can go to check this option? thank you.