Baby Partner programming?

[brucealmighty]

I cannot remember for the life of me how to change date/time on a "baby" partner (206 stand alone).
i've looked in past forums, checked out links (dead). Checked avaya support, not finding anything.
Please any help would be great. Its not a huge deal, but when customer is trying to upgrade finally we techs wanna act like we know what we are doing

 

[TouchToneTommy]

Should be the same as a regular Partner

#101 Date
#103 Time

http://www.wedophones.com/Manuals/AT&T/Partner R4-0 Installation and Use.pdf

 

[sysconsultant]

What we called Baby Partner is called Basic Partner in the docs. It is very limited in features and doesn't display the system programming prompts when you enter programming mode, so it is confusing. It doesn't have a cycle mode, so "Next Procedure", "Next Item", etc doesn't exist. You can only program at X10 - but it doesn't require a display phone. Follow the regular method of programming:
Press F00, left intercom twice. Use the codes above, enter the data, then exit programming mode. A display phone will show the new date and time.

 

[brucealmighty]

When entering the usual "LI twice", Press #101 all I get on the screen in #101. I don't see the date, or anything that would prompt me to change it like the ACS does.
Do you just enter #101 then put the date in after it and it takes it?

 

[sysconsultant]

Yes, programming isn't displayed. Just enter the date, go out of programming mode and see if it took.