[b]Remote Call Forward ?[/b]

[2newphoneguys]

Does remote call forward work on a 2616 on CS1000M Rel. 5.5 or is it only 3900 series and VOIP sets?

 

[KCFLHRC]

Yes, it will work on a 2616

 

[2newphoneguys]

Well then I'm in a pickle because I can get my 3900 sets to work just fine, but my 2616's do not...with the same COS features turned on (specifically CFXA). Would you have any suggestions to point in the right direction? I guess what I'm asking for is the steps to make sure the 2616 is programmed properly.

 

[KCFLHRC]

LD 11 - Set the Station Control Password and allow Call Forward.
Prompt Response Description
REQ: CHG Change existing data.
TYPE: a...a Telephone type. Type ? for a list of possible responses.
TN Terminal number
l s c u Format for Large System and CS 1000E system, where l =
loop, s = shelf, c = card, u = unit.
c u Format for Small System and Media Gateway 1000B where c =
card and u = unit.
SCPW xxxxxxxx Station Control Password (0 to 8 digits, defined in LD 15).
KEY xx CFW 4-(16)-23 Assign Call Forward key (xx) and set the forwarding DN length.

 

[2newphoneguys]

I DIDN'T SET THE CFW TO ALLOW FOR MAXIMUM NUMBER OF DIGITS ON THE CFW KEY....THANKS!