really odd one here as we are being handed ISDN2 lines off an Ericsson via an S0 adaptor as it passes off to our Avaya MM720 card and have setup the BRI board & trunk group .
the system is in Rotterdam
S8300
CM5.2.1
Avaya 9600 sets
Avaya MM720 board
seeing the line in-service in CM but when calling said numbers I see my trunk go active but nothing is being passed as in seeing no digits from the Ericsson system -
as I understand the S0 adaptor converts the signal from the Ericcson system too something the BRI board can understand -
setup as enblcoc/enbloc in my trunking as they are sending 4 digits on the call
if I setup my trunk group as overlap/enbloc and insert digits in the trunk group form to match a singular extension the call routes through to the singular end point and we get audio in both directions so it appears my BRI board settings and trunk settings are fine just not seeing any digits from them – even if it was the wrong number of digits I should see something.
if the Ericsson techs disconnects the S0 adaptor and connects a PTT Telecom ISDN Vox 930 phone he can make and receive calls just not sure of the conversion and what we should be setup as I expected a line from a carrier / provider not coming off another system.
I have Setup BRI before in the past but this one has me guessing when coming off another system.
cheers !
ayavauser
the system is in Rotterdam
S8300
CM5.2.1
Avaya 9600 sets
Avaya MM720 board
seeing the line in-service in CM but when calling said numbers I see my trunk go active but nothing is being passed as in seeing no digits from the Ericsson system -
as I understand the S0 adaptor converts the signal from the Ericcson system too something the BRI board can understand -
setup as enblcoc/enbloc in my trunking as they are sending 4 digits on the call
if I setup my trunk group as overlap/enbloc and insert digits in the trunk group form to match a singular extension the call routes through to the singular end point and we get audio in both directions so it appears my BRI board settings and trunk settings are fine just not seeing any digits from them – even if it was the wrong number of digits I should see something.
if the Ericsson techs disconnects the S0 adaptor and connects a PTT Telecom ISDN Vox 930 phone he can make and receive calls just not sure of the conversion and what we should be setup as I expected a line from a carrier / provider not coming off another system.
I have Setup BRI before in the past but this one has me guessing when coming off another system.
cheers !
ayavauser