Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

avaya merlin magix

Status
Not open for further replies.
Dec 16, 2001
7,968
US
You can access system programming from a 4424LD+ connected to one of the 1st 5 ports.

Are you sure you are plugged into the same line port as before? There is a 5th jack for PFT, did you accidentally plug into that, instead of the correct line jack?

Find out what the paging button on the phones is dialing - go to a phone, press SPKR, #00, then press the paging button. You should see something like "pickup L804" - that will tell you which line jack you should be using.
 
Hi,
I get no activity on ports 1-3 of the first card and when I use the 4424LD+ on the fourth port i get no option for system program only ext program. I'm sure im in the same port (they were marked).
I was told that they used to press 5 to get into the paging system, there is no button setup for paging.
 
Check the seating of the Amphenol connector if the first few extensions are dead. Just 5, they renumbered a pool to 5 and put the paging trunk in the pool. Poor way to do it, but it will work. You would want to go in programming to Lines & Trunks, Pools, pool 5, and then Entry Mode, Inspect to see which line it is.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top