Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Avaya Magix Operator Positions

Status
Not open for further replies.

Sasquatch1921

Programmer
Aug 28, 2019
7
US
Hello,
I have several Magix systems that were programmed with all operator Positions. This was completely unnecessary. It's been many years since I e dealt with this and am in need for a little help. I tried to delete the unwanted positions, but the system won't allow it. I remember it was easy to delete during initial programming. Can someone assist in deleting the unwanted Positions without starting from scratch? I know the Magix can be tricky. Thanks aa
 
You need to go to "Operator Positions" in SPM (System Programming) and delete them from there.
 
That's under "operators" in system programming, right? I did try to delete under that and did not work. Maybe I'm in the wrong section? Thanks for your reply.
 
are you possibly skipping/overlooking the last "save" action?
before you start, make two new backups.
there may have been a practical reason for eight operator positions.
of course you should expect a system reboot

42
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top