Avaya IP office with contact closure setup 1

[edlee321]

I am moving offices and I am upgrading from a partner to an IP office system.

Can someone link me to all the parts I need to put together a 12v cantact closure adjunct to the 3mm jack in the back of the ip500v2.

Also, I have a viking c2000b 4 door controller and my old Avaya contact closure from partner system. Is it possible to hook up the 3.5mm jack to the viking c2000b controller so I don't have to assemble a homemade relay?

The best info I read so far was from ttt, but it didn't get 100% specific, when he said "You'll need to assemble your own contact closure adjunct to connect to the 3.5mm jack on the back of the IPO. A 12VDC power cube and a couple of 12V relays is all you need. For $20 I put together a kit for one relay, in a project box, with a terminal strip for connecting to the door opener itself. Program the relay button on a set, or use a short code to cycle the relay for 5 seconds. Works great.

 

[mforrence]

For example:
One Altronix RB1224 DPDT relay
One 3.5MM phono jack w/3 segments
One 12VDC Power supply 100ma minimum

Note that there are many many many other parts combos that will work just fine.
Note that the C2000B provides contact closures; if you're using it, the IPO contacts are likely a duplication of effort.

 

[edlee321]

The main thing I need to be able to do is pulse the door open without having the door phone to dial first or while I'm on the phone with another extension. I had this feature with the Avaya partner, and it made life great.

Can I do this with the c2000b door controller, or only the 3.5mm jack in the back of the ip500v2

 

[mforrence]

It is unlikely that you can use the C2000B to open a door without making a connection to it first. I believe that you CAN operate the IPO relay while on another call, but you should certainly try it in controlled circumstances to be sure.

 

[edlee321]

can someone construct the 12v relay to 3mm plug and ship it to NYC and I will pay by paypal?

 

[Telecomboy]

You should be able to use the C2000B door controller the same as the Partner. If it is connected to a line port on the Partner, connect it to a line port on the IPO. If it was connected to an extension on the Partner, connect it to an analog extension port on the IPO. If connecting to a line port, make sure the IPO is set to loop start versus loop start caller ID.

 

[edlee321]

I didnt use the c2000b before, i had the partner contact closure adjunt before, but I dont think its compatible with IPO.
The way it worked on partner is that there was a contact closure jack and you ran it to the contact closure adjunct, and you program the phone to use Feaure 41 to pulse the doors.

I believe on the IPO i have to use the 3.5mm jack in order to program door pulse while i am on the phone.

 

[derfloh]

With the inbuilt relay it is possible to open a door without having to speak to a door phone first and it is possible to activate the relay during a phone call.

 

[TouchToneTommy]

 

[edlee321]

I bought the altronix relay, 3.5mm cable, and 12vDC power supply.

The 12v connection to the relay i understand, can you please guide me through wiring from 3.5mm to which side of the relay, and which side of the relay should I send to NO NC C of the door strike?

http://www.altronix.com/products/installation_instructions/RB1224.pdf

 

[edlee321]

Hey mforrence, can you please tell me how to wire this relay?